🧰 How to Install RodentBarrier 360 Tire Rings (Step-by-Step Guide)
Share
Installing your RodentBarrier 360 system is quick and easy—but following the right steps is key for maximum protection. Here’s how to do it:
✅ What You’ll Need:
A flat, level surface (cement, blacktop, or plywood)
Your RodentBarrier 360 kit (rings, magnets, gloves, glasses, and trap)
Floor cracks less than ¼” wide (or use plywood to cover larger gaps)
🛠️ Installation Steps:
Safety First: Put on the included gloves and safety glasses. Be careful when removing the tire rings—they’re under tension and have sharp edges.
Place the Rings: Wrap one tire ring around each tire. (Dual tire versions are available if needed.)
Secure with Magnets: Attach 4 magnets per ring—2 on top (inside and outside) and 2 on the bottom. Important: The ring should not touch the tire in case it deflates during storage.
Check the Surface: Make sure the rings sit flush against the floor. If there are cracks wider than ÂĽ", cover the area with plywood or reposition the vehicle to maintain the barrier.
Set the Trap: Place the included bait trap just inside the door of your camper or vehicle. For severe rodent issues, use 2–3 traps near the entryway. There’s no need to place traps throughout the interior—rodents will find their way to the bait.
🔍 Pro Tips:
Check traps daily for the first week or until no more mice are caught.
Randomly check your vehicle throughout the storage season.
This system only targets mice, not rats or squirrels—those require separate traps.
🧼 Why It Matters:
Mice don’t just cause damage—they can carry diseases like Hantavirus and leave behind hard-to-remove odors. With proper installation, RodentBarrier 360 gives you long-term peace of mind. It’s been tested for 20+ years—with zero mice getting through when installed correctly.
Take control. Stop rodents before they get in.
No mice = no damage, no disease, no smell.
Got questions or need extra traps or parts? Visit our shop for more options!